ISL7202xSEH Rad Tolerant 3.3V CAN Transceivers

Added on November 13, 2015
Learn about Intersil's first rad tolerant 3.3V CAN transceivers that are fully QML-V qualified and compliant with the ISO11898-2 physical layer standard.

Related Resources

ISL72026SEH Datasheet ISL72026SEH Datasheet

isl72026seh.pdf (876 KB)
Oct 2017

ISL72027SEH Datasheet ISL72027SEH Datasheet

isl72027seh.pdf (874 KB)
Oct 2017

ISL72028SEH Datasheet ISL72028SEH Datasheet

isl72028seh.pdf (867 KB)
Oct 2017

ISL7202xSEHEVAL1Z User Guide ISL7202xSEHEVAL1Z User Guide

isl7202xseheval1z-user-guide.pdf (715 KB)
Oct 2015

 


Video Transcript

Hello, my name is Josh Broline, the Mil and Aero Marketing Manager for Intersil Corporation. I am excited to introduce to you Intersil's first radiation tolerant 3.3 volt CAN Bus transceiver family, ISL72026SEH, ISL72027SEH and the ISL72028SEH.

There have been a few mainstay communication protocols that have been used for years in typical satellite designs such as RS-422 and Mil-Standard 1553. These have been very robust and reliable communication protocols for some time so they were used over and over again.

However, these protocols have their limitations. RS-422 and Mil-standard 1553 have a limit of how many nodes can be on one Bus, do not have the same ease of use when it comes to data prioritization, it can consume much more power. The RS-422 and Mil-standard 1553 protocols are often used in point-to-point communication designs, which greatly increase the amount of cables that are required versus CAN Bus protocol. With the introduction of a true CAN Bus transceiver, the total solution will be complete.

System engineers are excited to start flying a true CAN Bus transceiver for several reasons. Just to name a few, using Intersil's CAN Bus transceiver, power consumption will be reduced, the solution footprint will be reduced, true cold spare capability for redundant applications will be possible, and a radiation single event effects tolerant solution will be available.

Intersil's devices are compatible to the ISO11898-2 specification, in our guaranteed wafer by wafer to 75KRS with a low dose ray exposure of 10mil Rads a second. Up to 120 nodes or transceivers can be connected to a single CAN Bus to reduce cabling, weight, power cost, also known as swap.

The devices operate off of a 3.3 volt bias voltage, but have a bus fault protection up to +/-18 volts, even under a heavy ion environment, but particle energies up to 60MeV. Also, the transceivers can operate up to speeds of 1 megabytes per second, which is in line with the ISO standard.

We offer three different products in this family. The ISL72026SEH has a loop back feature which provides a node diagnostic mode. The ISL72027SEH offers a split mode feature which helps improve EMI and EMC. The ISL72028SEH has a low power shut down mode. We offer a complete set up supporting tool such as evaluation boards, data sheets, SEE, radiation report, SPICE, and IBIS models.

For more information please visit www.intersil.com/products/ISL72026SEH. Thank you for watching.