Device Information
 
 
ISL6117 Printer Friendly Version
 
Power Distribution Controllers
 
Datasheets,
Related Docs
& Simulations
DescriptionKey
Features
Parametric
Data
Application
Diagrams
Related
Devices
 
 
Ordering Information
 iBuy direct from Intersil  iBuy direct - out of stock  Request samples
 Check distributor inventory Green/Pb(Lead free) Device  Available in RoHS/Pb-Free  
Part No. Design-In
Status
Temp. Package MSL Price
US $
PB Free
ISL6117CBZA Active Comm 8 Ld SOIC 1 1.58 PB Free Disti-Buy  
ISL6117CBZA-T Active Comm 8 Ld SOIC T+R 1 1.58 PB Free Disti-Buy  
ISL6117CB InActive Comm 8 Ld SOIC 1 N/A      
ISL6117CB-T InActive Comm 8 Ld SOIC T+R 1 N/A      
The price listed is the manufacturer's suggested retail price for quantities of 1K units. However, prices in today's market are fluid and may change without notice.
MSL = Moisture Sensitivity Level - per IPC/JEDEC J-STD-020
SMD = Standard Microcircuit Drawing
 
  Description

This family of fully featured hot swap power controllers targets applications in the +2.5V to +12V range. The ISL6115 is for +12V control, the ISL6116 for +5V, the ISL6117 for +3.3V and the ISL6120 for +2.5V control applications. Each has a hard wired undervoltage (UV) monitoring and reporting threshold level approximately 80% of the aforementioned voltage.

The ISL6115 has an integrated charge pump allowing control of up to +16V rails using an external N-Channel MOSFET whereas the other devices utilize the +12V bias voltage to fully enhance the N-Channel pass FET. All ICs feature programmable overcurrent (OC) detection, current regulation (CR) with time delay to latch-off and soft-start.

The current regulation level is set by 2 external resistors; RISET sets the CR Vth and the other is a low ohmic sense element across, which the CR Vth is developed. The CR duration is set by an external capacitor on the CTIM pin, which is charged with a 20μA current once the CR Vth level is reached. If the voltage on the CTIM capacitor reaches 1.9V the IC then quickly pulls down the GATE output latching off the pass FET.

This family although designed for high side switch control the ISL6116, ISL6117, ISL6120 can also be used in a low side configuration for control of much higher voltage potentials.

 
  Key Features
 
  • HOT SWAP Single Power Distribution Control (ISL6115 for +12V, ISL6116 for +5V, ISL6117 for +3.3V and ISL6120 for +2.5V)
  • Overcurrent Fault Isolation
  • Programmable Current Regulation Level
  • Programmable Current Regulation Time to Latch-Off
  • Rail-to-Rail Common Mode Input Voltage Range (ISL6115)
  • Internal Charge Pump Allows the Use of N-Channel MOSFET for +12V Control (ISL6115)
  • Undervoltage and Overcurrent Latch Indicators
  • Adjustable Turn-On Ramp
  • Protection During Turn-On
  • Two Levels of Overcurrent Detection Provide Fast Response to Varying Fault Conditions
  • 1μs Response Time to Dead Short
  • Pb-Free Available (RoHS Compliant)
Related Documentation
 
Datasheet(s)   Datasheet(s):
 
Technical Brief(s)   Technical Brief(s):
 
 
  Parametric Data
System Management: System Resets, Power Indicators, Fault DetectionY
Adjustable Gate RampY
Advanced Fault ProtectionY
VBIAS (V)12
Controlled Voltages (V)3.3
Regulation or Latch-Off for OvercurrentCurrent Regulation
Adjustable or Fixed OC VTHAdjustable
Int/Ext FETExt
UV/OV FeatureUV Lockout
ReportingPGOOD + Fault Off
 
  Application Block Diagrams
 
 
 
Applications
 
  • Power Distribution Control
  • Hot Plug Components and Circuitry
 
  Related DevicesParametric Table   Parametric Table
 
 ISL6115 Power Distribution Controllers 
 ISL6115A 12V Power Distribution Controllers 
 ISL6116 Power Distribution Controllers 
 ISL6120 Power Distribution Controllers 
 ISL6140 Negative Voltage Hot Plug Controller 
 ISL6141 Negative Voltage Hot Plug Controller 
 ISL6142 Negative Voltage Hot Plug Controller 
 ISL6150 Negative Voltage Hot Plug Controller 
 ISL6151 Negative Voltage Hot Plug Controller 
 ISL6152 Negative Voltage Hot Plug Controller 

 

About Us | Careers | Contact Us | Investors | Legal | Privacy | Site Map | Subscribe | Intranet

©2003-2009. Intersil Americas Inc. All rights reserved.