The price listed is the manufacturer's suggested retail price for quantities of 1K units. However, prices in today's market are fluid and may change without notice.
MSL = Moisture Sensitivity Level - per IPC/JEDEC J-STD-020
SMD = Standard Microcircuit Drawing
Description
This fully featured hot swap power controller targets +12V applications. The ISL6115A with its integrated charge pump has a higher (6.5V vs 5V) gate drive than its sister part the ISL6115 making this part an immediate efficiency improvement replacement.
This IC features programmable overcurrent (OC) detection, current regulation (CR) with time delay to latch-off and softstart.
The current regulation level is set by 2 external resistors; RISET sets the CR Vth and the other is a low ohmic sense element across, which the CR Vth is developed. The CR duration is set by an external capacitor on the CTIM pin, which is charged with a 20μA current once the CR Vth level is reached. If the voltage on the CTIM capacitor reaches 1.9V the IC then quickly pulls down the GATE output latching off the pass FET.
Key Features
HOT SWAP Single Power Distribution Control for +12V
Overcurrent Fault Isolation
Programmable Current Regulation Level
Programmable Current Regulation Time to Latch-Off
Rail-to-Rail Common Mode Input Voltage Range
Enhanced Internal Charge Pump Drives N-Channel MOSFET gate to 6.5V above IC bias.
Undervoltage and Overcurrent Latch Indicators
Adjustable Turn-On Ramp
Protection During Turn-On
Two Levels of Overcurrent Detection Provide Fast Response to Varying Fault Conditions
