The HS-1840ARH is a radiation hardened, monolithic 16 channel multiplexer constructed with the Intersil Rad-Hard Silicon Gate, bonded wafer, Dielectric Isolation process. It is designed to provide a high input impedance to the analog source if device power fails (open), or the analog signal voltage inadvertently exceeds the supply by up to ±35V, regardless of whether the device is powered on or off. Excellent for use in redundant applications, since the secondary device can be operated in a standby unpowered mode affording no additional power drain. More significantly, a very high impedance exists between the active and inactive devices preventing any interaction. One of sixteen channel selection is controlled by a 4-bit binary address plus an Enable-Inhibit input which conveniently controls the ON/OFF operation of several multiplexers in a system. All inputs have electrostatic discharge protection.

The HS-1840ARH is processed and screened in full compliance with MIL-PRF-38535 and QML standards. The device is available in a 28 lead SBDIP and a 28 lead Ceramic Flatpack.

Specifications for Rad Hard QML devices are controlled by the Defense Supply Center in Columbus (DSCC). The SMD numbers listed here must be used when ordering.

Detailed Electrical Specifications for these devices are contained in SMD 5962-95630. A "hot-link" is provided on our homepage for downloading.
http://www.intersil.com/spacedefense/space.htm

• Electrically Screened to SMD # 5962-95630
• QML Qualified per MIL-PRF-38535 Requirements
• Pin-to-Pin for Intersil's HS-1840RH and HS-1840/883S
• Improved Radiation Performance
  • Gamma Dose 3 x 10⁵RAD(Si)
• Improved r_DS(ON) Linearity
• Improved Access Time 1.5µs (Max) Over Temp and Post Rad
• High Analog Input Impedance 500MΩ During Power Loss (Open)
• ±35V Input Over Voltage Protection (Power On or Off)
• Dielectrically Isolated Device Islands
• Excellent in Hi-Rel Redundant Systems
• Break-Before-Make Switching
• No Latch-Up