- 450mA output drive capability
- 44.4VP-P differential output drive into 100Ω
- ±5V to ±15V supply operation
- MTPR of -70dB
- Operates down to 2mA per amplifier supply current
- Current control pins
- Channel separation
- 80dB at 500kHz
- Direct pin-to-pin replacement for EL1528
- RoHS compliant
The ISL1532 is a dual channel differential amplifier designed for driving full rate ADSL2+ signals at very low power dissipation. The high drive capability of 450mA makes this driver ideal for DMT designs. It contains two pairs of wideband, high-voltage, current mode feedback amplifiers designed on Intersil’s HS30 Bipolar SOI process for low power consumption in DSL systems.
These drivers achieve an MTPR distortion measurement of better than 70dB, while consuming typically 5mA per DSL channel of total supply current. This supply current can be set using a resistor on the IADJ pin. Two other pins (C0 and C1) can also be used to adjust supply current to one of four preset modes (full-IS, 3/4-IS, 1/2-IS and full power-down). C0 and C1 inputs are design to pull high initially. Floating these inputs will put the device in disable mode. This is contrary to EL1528 where C0 and C1 inputs pull low initially and is in the enable state when C0 and C1 pins are floated.
The ISL1532 operates on ±5V to ±15V supplies and retains its bandwidth and linearity over the complete supply range.
The device is supplied in a thermally-enhanced 20 Ld HTSSOP and the small footprint (4x5mm) 24 Ld QFN packages. The ISL1532 is specified for operation across the full -40°C to +85°C temperature range.
The ISL1532 provides larger output swing at heavy loads, higher slew rate and higher bandwidth while maintaining pin-to-pin drop-in compatibility with the EL1528. The ISL1532 integrates 50k pull-up resistors on C0 and C1 pins
- Dual port ADSL2+ line drivers
- HDSL line drivers
|Bandwidth||50 MHz||60 MHz||40 MHz||50 MHz|
|# of Devices/ Channels||2||2||2||2|
|Slew Rate||400 V/μs||400 V/μs||400 V/μs||400 V/μs|
|VS (min)||8 V||8 V||8 V||8 V|
|VS (max)||30 V||30 V||30 V||30 V|
|IS (per amp)||4.9 mA||4 mA||3.9 mA||3 mA|
|Noise VN||3.5 nV/√Hz||10 nV/√Hz||7 nV/√Hz||8 nV/√Hz|
|IBIAS (max)||14 µA||7.5 µA||5 µA|
|VOS (max)||10 mV||10 mV||40 mV|
|IOUT||450 mA||450 mA||450 mA||600 mA|
|VOUT||22.2 V||22.2 V||22.2 V||21.7 V|
|PSRR||55 dB||55 dB||55 dB||59 dB|
|THD||72 dB||68 dB||68 dB||69 dB|