EL4393
Triple 80MHz Video Amplifier w/Disable
Not Recommended for New Designs.Contact our Technical Support Center at 1-888-INTERSIL.
Typical Diagram
Key Features
- 80MHz -3dB bandwidth for gains of 1 to 10
- 900V/µs slew rate
- 10MHz bandwidth flat to 0.1dB
- Excellent differential gain and phase
- TTL/CMOS compatible
- Available in SOL-16
Description
The EL4393 is three wideband currentfeedback amplifiers optimized for video performance. Each amplifier can drive a load of 150Ω at video levels. Each amplifier has a disable capability, which is controlled by a TTL/CMOS compatible logic signal. The EL4393 operates on supplies as low as ±4V up to ±15V.
Being a current-feedback design, the bandwidth stays relatively constant at approximately 80MHz over the ±1 to ±10 gain range. The EL4393 has been optimized for use with 1300Ω feedback resistors at a gain of 2. When the outputs are disabled, the supply current consumption drops, by about 4mA per channel that is disabled. This feature can be used to reduce power dissipation.
Applications
- RGB drivers
- RGB multiplexers
- RGB gain blocks
- Video gain blocks
- Coax cable driver
- ADC drivers/input multiplexer
